GV-GPS Receiver

The GV-GPS Receiver can work with GV-System, GV-DSP LPR, GV-Video Server and GV-Compact DVR to perform GPS vehicle tracking. It comes with three types of models: UART, RS-232, and USB. Each model can only work with appropriate Hardware and Firmware version as described below:

Model	Interface	Baud Rate	Compatible IP Device
GV-GPS UART	UART	9600	GV-Video Server (GV-VS02A)		Firmware Version 1.00 or later
			GV-Video Server (GV-VS04A)
			GV-Video Server (GV-VS14)
			GV-Video Server (GV-VS04H)		Firmware Version 1.04 or later
GV-GPS 232	RS-232 Wires	9600	GV-DSP LPR V2 / V3		Firmware Version 1.06 or later
			GV-Video Server (GV-VS12)		Firmware Version 1.00 or later
			GV-Compact DVR V1		Firmware Version 1.52 or later
			GV-Compact DVR V2	Standard Model (GV-LX4C2)	Firmware Version 1.00 or later
				Anti-Vibration Model (GV-LX4C2V)
	PS/2 Connector	9600		Anti-Vibration ACC Model (GV-LX4C2V)	Firmware Version 1.05 or later
			GV-Compact DVR V3	Anti-Vibration ACC Model (GV-LX4C3V, GV-LX8CV1, GV-LX8CV2)	Firmware Version 1.00 or later
GV-GPS USB	USB Connector	4800	GV-System		Firmware Version 8.3.2 or later

Note: Specifications are subject to change without notice.

GV-Relay V2

The GV-Relay V2 is designed especially for driving higher voltage output devices, and it is controlled by other GV devices, such as GV-Video Server, GV-Compact DVR, GV-IP Camera, GV-DSP LPR, GV-I/O USB Box and GV-NET/IO Card V3.1.

The GV-Relay V2 provides 4 relay outputs, and each output can be set as normally open (NO) or normally closed (NC) independently as per your requirement.

GV-VR605A DC Voltage Regulator

The GV-VR605A is a voltage regulator designed to be installed in the car and supply power to GV-Video Server and its connected cameras. The GV-VR605A is capable of maintaining a 12V voltage to the GV-Video Server and its connected cameras, providing protection against voltage spikes when you turn on the car ignition. After you turn off the car ignition, the GVVR605A will continue supplying power to the GV-Video Server for 75 seconds during which GV-Video Server will stop recording, remove the hard drive from the system and then turn off automatically. The GV-VR605A features 5 power outputs to power the GV-Video Server and its connected cameras.

GV-PA191 PoE Adapter

The GV-PA191 is a Power over Ethernet (PoE) adapter designed to provide power to the IP device through a single Ethernet cable. Adopting the PoE adapter enables you to mount an IP device anywhere in a building where power outlets are not available.